NETGEAR FVS318 - ProSafe VPN Firewall Router Reference Manual page 30

Reference Manual for the Model FVS318 Broadband ProSafe VPN Firewall
Click Next and follow the steps in the Setup Wizard for inputting the configuration
b.
parameters from your ISP to connect to the Internet.
Note: If you choose not to use the Setup Wizard, you can manually configure your
Internet connection settings by following the procedure
Your Internet Connection" on page
Unless your ISP automatically assigns your configuration automatically via DHCP, you
will need the configuration parameters from your ISP as you recorded them previously in
"Worksheet for Recording Your Internet Connection Information" on page
When the firewall successfully detects an active Ethernet connection with a broadband
c.
modem, the firewall's Internet LED goes on. The Setup Wizard reports which connection
type it discovered, and displays the appropriate configuration menu. If the Setup Wizard
finds no connection, you will be prompted to check the physical connection between your
firewall and the cable or DSL line.
The Setup Wizard will report the type of connection it finds. The options are:
d.
• Connections which require a login using PPPoE, DHCP, or Static (Fixed) IP
connections. For PPTP or Telstra Bigpond Cable broadband, please refer to
Manually Configure Your Internet Connection" on page
• Connections which use dynamic IP address assignment.
• Connections which use fixed IP address assignment.
The procedures for filling in the configuration menu for each type of connection follow
below.
3-8
"How to Manually Configure
3-13.
Connecting the Firewall to the Internet
M-10146-01
3-3.
"How to
3-13.