Testing The Lan Path To Your Firewall; Testing The Path From Your Pc To A Remote Device - NETGEAR FVS318 - ProSafe VPN Firewall Router Reference Manual

Reference Manual for the Model FVS318 Broadband ProSafe VPN Firewall

Testing the LAN Path to Your Firewall

You can ping the firewall from your PC to verify that the LAN path to your firewall is set up
correctly.
To ping the firewall from a PC running Windows 95 or later:
From the Windows toolbar, click on the Start button and select Run.
1.
In the field provided, type Ping followed by the IP address of the firewall, as in this example:
2.
ping 192.168.0.1
Click on OK.
3.
You should see a message like this one:
Pinging <IP address> with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, you could have one of the following problems:
• Wrong physical connections
— Make sure the LAN port LED is on. If the LED is off, follow the instructions in
"Local or Internet Port Link LEDs Not
— Check that the corresponding Link LEDs are on for your network interface card and
for the hub ports (if any) that are connected to your workstation and firewall.
• Wrong network configuration
— Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your PC or workstation.
— Verify that the IP address for your firewall and your workstation are correct and that
the addresses are on the same subnet.

Testing the Path from Your PC to a Remote Device

After verifying that the LAN path works correctly, test the path from your PC to a remote device.
From the Windows run menu, type:
8-6
On" on page
M-10146-01
8-2.
Troubleshooting