Fujitsu FI-6750S Operator's Manual page 120

Chapter 6 Daily Care
Feed Rollers
The cleaning procedure is as follows:
Feed Roller (x4)
1 With the power on, open the ADF when the Operator Panel indicates
a code other than "P."
Note that the Feed Rollers will not rotate if you open the ADF and do
the following action while "P" is indicated.
2 Hold down the [Send to] and [Scan/Stop] buttons simultaneously on
the Operator Panel. The Feed Rollers and Eject Rollers start to rotate
by a certain angle.
Both the Feed Rollers and Eject Rollers turn at
AUTION
the same time. Do not touch the Feed Rollers
or Eject Rollers during cleaning if they are
rotating.
3 Hold a soft cloth moistened with Cleaner F1 against the surface of the
rotating Feed Rollers and Eject Rollers so that the cloth wipes off the
surface of the rollers lightly. Take particular care in cleaning these
rollers as black debris on them adversely affects the feeding perfor-
mance.
As a guideline, seven presses of the [Send to] and [Scan/Stop]
buttons together makes the Feed Rollers to rotate one full turn.
ADF type
Function Number Display
[Scan/Stop] button
[Send to] button
Function
Scan / Stop
Power
Check
Send to
Flatbed type
Check
Function Number Display
Function
Send to
[Send to] button
Scan / Stop
[Scan/Stop] button
Power
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
120