Fujitsu FI-6750S Operator's Manual page 112

Chapter 5 Various Documents
■With FUJITSU ISIS Scanner Driver
1
Start up ScandAll PRO, select the [Scan] menu
Settings].
⇒
The FUJITSU ISIS scanner driver's setting dialog box appears.
2
Select the [Paper Handling] tab, and then select:
•
[Enable] and [Paper Overlap] under [Multifeed Detection]
•
[On] under [Multifeed Recovery]
3
Specify a desired time (in minutes) at [Auto-cancel Timer].
Operating the Scanner
1
After a multifeed error has occurred, press the [Send to]
button to eject the document from the paper feed path, or
open the ADF and remove the sheets from there.
When the sheets are removed, the function number displayed
changes as follows:
At multifeed error
"J" and "2" are indicated
[Scan
alternately.
2
Return the ejected or removed sheets to the ADF Paper
Chute.
If a multifeed error is detected while no paper has been glued on the
sheet, press the [Scan/Stop] button or restart the scanning via the
computer. (In this case, do not press the [Function] button.)
If glued paper is present on the removed/ejected sheet and this is
likely the cause of the multifeed error, then go to the next step:
ADF Type
Function Number Display
Check
Flatbed Type
At document ejecting
The corresponding function
number blinks.
[Function] button
[Send to] button
Function
Scan / Stop
Power
[Scan/Stop] button
Send to
Check
Function Number
Display
Function
[Function] button
Send to
[Send to] button
Scan / Stop
[Scan/Stop] button
Power
TOP
Contents
Index
Introduction
Scanner
Overview
Loading
Documents
How to Use
ScandAll PRO
Scan Pa-
rameters
Various
Documents
Daily Care
Consumables
Trouble-
shooting
Operational
Settings
Appendix
Glossary
112