Configuration File Operation Command; Copy Running-Config Startup-Config; Show Running-Config - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.5 Configuration File Operation Command

This section explains the commands related to configuration file and file operation in the volatile memory.

5.5.1 copy running-config startup-config

Function
Stores the configuration file (running-config) in the volatile memory, on which the system is currently operating, to
startup-config in nonvolatile memory.
When changing the setting of running-config, use the setting when it is used after restarting the system.
Prompt
xg#
Command syntax
copy running-config startup-config
Command type
Operation management commands
Note
When the system is restarted without saving the information of running-config in startup-config, the information set in
running-config will be lost.
Be sure to upload the contents of the startup-config file to a TFTP server because the contents will be overwritten.
Example
Store running-config in startup-config. Then, check the information of startup-config using the show command.
xg# copy running-config startup-config
xg# show startup-config

5.5.2 show running-config

Function
Displays the configuration information (running-config) in the currently operating volatile memory.
Prompt
xg#
Command syntax
show running-config
Command type
Operation management commands
Example
Display the content of running-config.
xg# show running-config
76/258
All Rights Reserved, Copyright (C) PFU LIMITED 2005