Spanning-Tree Port-Path-Cost - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.9.9 spanning-tree port-path-cost

Function
Sets a path cost of each port.
Use the no form to return to the default setup.
Prompt
xg(config-if)#, or xg(config-agg)#
Command syntax
spanning-tree port-path-cost <1-200000000>
no spanning-tree port-path-cost
Parameter
port-path-cost <1-200000000>
Sets a path cost of each port. It can be within the range of 1 to 200000000.
The following path cost values are recommended by IEEE802.1D.
Link speed
100M bps
1G bps
10G bps
Command type
Configuration command
Configuration command Default
2 (16bit)
2000 (32bit)
Example
Set the path cost of switch port 2 to 3:
xg(config)# interface port 2
xg(config)# spanning-tree port-path-cost 3
IEEE802.1D (16bit)
Recommended
range
10 - 60
3 - 10
1 - 5
128/258
All Rights Reserved, Copyright (C) PFU LIMITED 2005
IEEE802.1D (32bit)
Recommended Recommended
value range
19 20000 - 2000000
4 2000 - 200000
2 200 - 20000
Recommended
value
200000
20000
2000