Workflow To Prepare The Xg1200; Setting Up Serial Interface - Fujitsu XG1200 User Manual

XG1200 User's Guide

3.1 Workflow to Prepare the XG1200

This section describes the procedures to setup the XG1200
1. Prepare an operation terminal
Prepare a terminal for the configuration.
2.

Setting Up Serial Interface

Connect the XG1200 and terminal with an RS232C cable. The initial setting of baud rate is 9,600bps.
3. Turn on the XG1200 to start the system.
Turn on the terminal and the XG1200 to start the system.
4. Configure Management LAN Interface
The initial setting of management LAN interface is disabled.
To use the following functions, set up the management LAN interface.
−
−
−
−
−
−
−
5. Telnet Connection via Management LAN Interface (Optional)
The initial setting of the Telnet connection via management LAN interface is disabled.
Enable telnet connection if necessary.
6. SNMP Configuration (Optional)
The initial setting of SNMP agent configuration is not set.
Set the SNMP configuration as needed.
7. This is the end of the preparation procedure
Proceed to setting switches.
3.1.1 Setting Up Serial Interface
Connect the XG1200 and terminal with an RS232C cable. The initial setting of baud rate is 9,600bps.
Refer to "Operating Environment for
For serial interface settings, only baud rate can be changed. To change the serial interface settings, carry out the following
procedure.
xg login: admin
Password: ********
xg> enable
xg# configure terminal
xg(config)# line console
xg(config-line)# baud-rate {9600 | 19200 |
38400 | 57600}
xg(config-line)# exit
xg(config)# terminal timeout console MINUTES
xg(config-line)# exit
xg(config)# exit
Telnet connection
SNMP manager connection
System log transmission
NTP server connection
Configuration file upload/download
Firmware update
Collection of maintenance information
CLI" for details on settings.
Command
All Rights Reserved, Copyright (C) PFU LIMITED 2005
Log in to the XG1200 frome the serial terminal.The default
user name is "admin". The default password is "password".
Switch to administrator EXEC mode.
Switch to global configuration mode.
Switch to serial terminal edit mode.
Change serial baud rate.
The baud rate is changed after the logout.
Exit to global configuration mode.
(Optional)
Set a monitoring period (in minutes) during which the serial
connection remains idle.
Exit to global configuration mode.
Exit to administrator EXEC mode.
22/258
Task