Ip Snooping Vlan Group-Member-Interval - Fujitsu XG1200 User Manual

XG1200 User's Guide
% Can't set mrouter on a port which belongs to an aggregation port.
Explanation
A port which configures a link aggregation cannot be specified for port.
Solution
Review the specified port number and reissue the command. When setting for the aggregation group specify
agg-port.
Example
Set aggregation group 1 as a multicast router port:
xg(config)# ip snooping vlan 2 mrouter agg-port 1

5.13.6 ip snooping vlan group-member-interval

Function
Sets an valid time (in seconds) of the IP multicast group which has been registered by IGMP snooping.
The registered IP multicast group is deleted if an IGMP Report message is not received within the valid time.
Use the no form to return to the default setup.
Prompt
xg(config)#
Command syntax
ip snooping vlan <1-4094> group-member-interval <60-600>
no ip snooping vlan <1-4094> group-member-interval
Parameter
vlan <1-4094>
Specifies a VLAN to change its settings.
group-member-interval <60-600>
Specifies the valid time period in seconds of the registered IP multicast group.
We recommend you to set "group member interval" by considering the message transmission interval of
the multicast router which is connected to the system. (This interval is called the "query interval" and its
default is 125 seconds in RFC.) The recommended value is as follows.
Command type
Configuration command
Default
260 seconds
Message
% Global IGMP snooping is not enabled.
Explanation
The global IGMP snooping of the XG1200 is disabled.
Solution
Enable the global IGMP snooping using the "ip snooping protocol" command first, then reissue the "ip snooping
vlan group-member-interval" command.
% Vlan id is not found. vid=%1$
Explanation
The specified VLAN has not been created.
[[Inserted string]]%1$: Specified VID
Solution
Create a VLAN using the "vlan" command first, then reissue the "ip snooping vlan group-member-interval"
command.
% IGMP snooping vlan-%1$ is not enabled.
Explanation
IGMP snooping of the specified VLAN is disabled.
[[Inserted string]]%1$: Specified VID
Solution
Enable the IGMP snooping of the VLAN using the "ip snooping vlan" command first, then reissue the "ip snooping
vlan group-member-interval" command.
Example
Set the valid of IP multicast group which has been learned at VLAN 1 to 300 seconds.
xg(config)# ip snooping vlan 1 group-member-interval 300
Group-member-interval = Query Interval
All Rights Reserved, Copyright (C) PFU LIMITED 2005
2 + 10 (seconds)
152/258