Serial/Telnet Configuration Commands; Terminal; Line - Fujitsu XG1200 User Manual

XG1200 User's Guide

5.3 Serial/telnet Configuration Commands

This section explains configuration commands related to serial connection/telnet connection.
5.3.1 terminal pager
Function
Enables or disables the pager function of the serial/telnet terminal.
Prompt
xg>, xg#
Command syntax
terminal pager { on | off }
Parameter
pager { on | off }
Specifies enable/disable of the pager.
−
−
Command type
Operation management commands
Default
on
Note
This command is effective until the terminal is disconnected.

5.3.2 line

Function
Switches to the terminal edit mode
Prompt
xg(config)#
Command syntax
line console
Parameter
console
Switches to the terminal edit mode of serial connection.
Command type
Configuration command
Example
Switch from the administrator exec mode to the terminal edit mode with the serial interface.
xg# configure terminal
xg(config)# line console
on
Enables the pager.
off
Disables the pager.
All Rights Reserved, Copyright (C) PFU LIMITED 2005
60/258