Table of Contents
Advertisement
SH-E514TR1 10 Gigabit Ethernet SmartPro Switch User Manual
Figure 9-18 Port Channel
Click Edit to re-configure the specific entry.
Click Back to return to the previous window.
L2 Multicast Control
IGMP Snooping
IGMP Snooping Settings
In order to use IGMP Snooping it must first be enabled for the entire Switch under IGMP Global Settings at the top of
the window. You may then fine-tune the settings for each VLAN by clicking the corresponding Edit button. When
enabled for IGMP snooping, the Switch can open or close a port to a specific multicast group member based on IGMP
messages sent from the device to the IGMP host or vice versa. The Switch monitors IGMP messages and
discontinues forwarding multicast packets when there are no longer hosts requesting that they continue.
Figure 9-19 IGMP Snooping Settings
The fields that can be configured are described below:
Global State: Enable or disable IGMP snooping global state.
VID: Enter a VLAN ID from 1 to 4094, and select to enable or disable IGMP snooping on the VLAN.
VID: Enter a VLAN ID from 1 to 4094.
Click Apply to accept the changes made for each individual section.
42
Advertisement
Table of Contents
