Cisco VS-C6509E-S720-10G User Manual page 420

C6576M QoS Policy Map Dialog Box
Figure 6-104 Policy Map Add Class Subdialog Box of C6576M QoS Policy Map Dialog Box
The following is shown in this subdialog box.
Class Name Area
• Class Name Table—Lists the classes by the Class Map Name.
• Class Map Name—Unique identifier of the policy map class on the device.
Type—Indicates whether the selected class map can be used on Ethernet interfaces or not. The
•
C65/76M EMS will discover class maps that are not suitable for use with Ethernet interfaces,
however you cannot add, remove, or configure these class maps. They are listed in the table only
to indicate that the class map names are in use. This attribute has one of the following values:
Aggregate Policer
Aggregate Enabled— Indicates whether or not an explicit policer is defined for the policy map class.
•
This enables QoS policing against Layer-3 switched traffic flows.
Named Aggregate—Unique string identifier of an aggregate policer on the device. This value is nil
•
if an explicit aggregate policer is defined within this policy map class. This is supported in Native
IOS only.
• Rate—Maximum transmission rate, in bits per second, to enforce against policed traffic. This value
is mandatory when defining an explicit policer. A value of 0 is returned on read if an explicit policer
is not defined for the policy map class.
Cisco 6500/7600 Series Manager User Guide
6-130
– ethernet—The class map can be used on Ethernet interfaces.
other—Indicates that a class map contains more than one match entry or it contains a match
–
criteria that is unsupported on Ethernet interfaces.
– empty—Indicates a class map with no match entries. An empty class map cannot be applied to
an Ethernet interface, however you may modify it.
Chapter 6 Logical Object Dialog Boxes