Table of Contents
Advertisement
Advanced Configuration
Port
STEP 1
STEP 2
STEP 3
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide
The Port > Static Link Aggregation window displays the current static link
aggregation settings.
To configure static link aggregation, follow these steps:
Click Port > Static Link Aggregation.
LAG displays the LAG number. Select the Port numbers to add the port to the LAG
group.
Click Save.
Configuring LACP Settings
Ports can be statically grouped into an aggregate link (that is, LAG) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a LAG link
between the switch and another network device. For dynamic LAGs, the switches
have to comply with LACP. This switch supports up to two LAGs. For example, a
LAG consisting of two 1000 Mbps ports can support an aggregate bandwidth of 4
Gbps when operating at full duplex.
5
21
Hide quick links:
Advertisement
Table of Contents
