Chapter 4: Setting Up The Cisco Slm2008 Switch; Launching The Web-Based Configuration Utility - Cisco SLM2008PT-NA Administration Manual

Setting Up the Cisco SLM2008 Switch

Launching the Web-Based Configuration Utility

STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide
This chapter describes how to configure the Cisco SLM2008 8-Port Gigabit Smart
Switch with PD and AC Power using the web-based configuration utility. The
following sections are included:
• Launching the Web-Based Configuration Utility, page 9
• Navigating the Utility, page 10
To configure the Cisco SLM2008 switch, follow these steps to access the web-
based configuration utility from your computer:
Connect your computer to the same network the Cisco SLM2008 switch is
connected to.
Make sure your computer is on the same subnet as the switch (192. 1 68. 1 .
By default, the Cisco SLM2008 switch has an IP address of 192. 1 68. 1 .254 and a
default subnet mask of 255.255.255.0.
Launch a web browser, such as Internet Explorer or Mozilla Firefox.
In the Address field, enter 192.168.1.254 and press Enter.
The default IP address is 192. 1 68. 1 .254. If the IP address has been changed,
NOTE
enter the assigned IP address instead of the default.
Press Enter. The web-based utility login window appears.
4
x ).
9