Table of Contents
Advertisement
Advanced Configuration
STP
STEP 3
STEP 4
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide
•
System Priority—Bridge priority is used in selecting the root device, root
port, and designated port. The device with the highest priority becomes
the STA root device. However, if all devices have the same priority, the
device with the lowest MAC address will then become the root device.
From the drop-down menu, select the value. The default value is 32768. The
range is 0 to 61440 in steps of 4096.
•
Hello Time—Enter the interval (in seconds) at which the root device
transmits a configuration message. The default is 2 seconds. The range is 0
to 10 seconds.
•
Max Age—Enter the maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure. The
default max age is 20 seconds. The range is 6 to 40 seconds.
•
Forward Delay—Enter the maximum time (in seconds) this device will wait
before changing states (i.e., discarding to learning to forwarding). The
default is 15 seconds. The range is 4 to 30 seconds.
Configure the STP port settings.
•
Port—Displays the port number.
•
Enable STP—Check the check box to enable STP on the port.
•
Port Fast—Check the check box to enable Port Fast on the port. If Port Fast
mode is enabled for a port, the Port State is automatically placed in the
Forwarding state when the port link is up. Port Fast optimizes the STP
protocol convergence.
•
Path Cost—The path cost is used to determine the best path between
devices. The default value is auto.
Click Save.
5
42
Hide quick links:
Advertisement
Table of Contents
