Qos; Stp; Statistics - Cisco SLM2008PT-NA Administration Manual

Setting Up the Cisco SLM2008 Switch
Navigating the Utility
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide
• 802.1X Settings—Configure security settings that include 802. 1 X mode,
RADIUS IP, Radius UDP port, key string or Admin State authentication mode.
• 802.1X Parameter—Enable re-authentication and configure the re-
authentication period or EAP timeout.
• Static MAC Address—Allows you to configure a switch port with the MAC
address of one or more devices that are authorized to access the network
through that port.
• Management Access List—Specifies which Source IP addresses can
manage the device.
• Storm Control—Configure the maximum rate (packets per second) at
which unknown packets are forwarded.

QoS

This window allows you to priortize network traffic and optimize network
performance using Quality of Service (QoS) settings.
• Queue Mode—Set the queue mode priority.
• QoS Mode—Configure the QoS mode settings including QoS disabled,
802. 1 p, port based, or Differentiated Services Code Point (DSCP).

STP

This window you to configure and view STP settings.
• STP Settings—Configure STP settings including system priority, hello time,
max age, and forward delay.
• STP Status—Displays the current STP status.

Statistics

This window displays statistics and IGMP status.
• Statistics Overview—Displays standard statistics on network traffic for
each port of the device.
• IGMP Status—Displays the IGMP status for each VLAN interface.
4
12