Stacking The Switches (Optional; Stacking The Switches (Optional) - Cisco ME-C3750-24TE-M Hardware Installation Manual

Appendix D Quick Setup By Using the CLI-Based Setup Program
Note
Note

Stacking the Switches (Optional)

78-15136-02
You need to provide the Category 5 straight-through cables to connect the switch
ports to other Ethernet devices.
On switches running Cisco IOS Release 12.1(14)EA1 or later, you can use the
mdix auto command to enable the automatic crossover feature. When the
automatic crossover feature is enabled, the switch detects the required cable type
and configures the interfaces accordingly. Therefore, you can use either a
crossover or a straight-through cable for all connections to an Ethernet port on the
switch.
The automatic crossover feature is disabled by default. For configuration
information for this feature, refer to the switch software configuration guide or the
switch command reference.
You can stack up to nine switches by using the StackWise cables and ports to
connect the switches.
Read the "Planning the Stack" section on page 3-12
switches.
Figure D-2 Stacking the Switches
CO NS OL
E
CO NS OL
E
CO NS OL
E
DC INP
UT S FO
PO WE R RE MO
RAT ING SP EC IFIE R SU PP TE
LY
100 -20 D IN MA
1.6 A-0 0V ~ +12 v NU AL
>9A , 50- @8 .5a
60 HZ
DC INP
UT S FO
PO WE R RE MO
SP EC IFIE R SU PP TE
RAT ING LY
100 -20 D IN MA
+12 v
1.6 A-0 0V ~ NU AL
>9A , 50- @8 .5a
60 HZ
DC INP
UT S FO
PO WE R RE MO
RAT ING SP EC IFIE R SU PP TE
LY
100 -20 D IN MA
1.6 A-0 0V ~ +12 v NU AL
>9A , 50- @8 .5a
60 HZ
Catalyst 3750 Switch Hardware Installation Guide

Stacking the Switches (Optional)

before you stack your
D-5