Attaching The Cable Guide - Cisco ME-C3750-24TE-M Hardware Installation Manual

Installing the Switch

Attaching the Cable Guide

Catalyst 3750 Switch Hardware Installation Guide
3-30
After the switch is mounted in the rack, you might need to perform these tasks to
complete the installation, run the setup program, and access the switch:
(Optional) Connect the switches in the stacks. See the
•
StackWise Cable to StackWise Ports" section on page
Connect to the console port, and start the emulation software. See the
•
"Connecting to the Console Port" section on page 1-4
Terminal Emulation Software" section on page
Power on the switch. See the
•
page 1-6. If the switches are stacked, see the
section on page 3-13.
Run the setup program. See the
•
page D-11.
Connect to the front-panel ports. See the
•
10/100/1000 Ports" section on page 3-44
Module" section on page 3-46
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference. To use CMS, go to the
Your Browser" section on page
We recommend attaching the cable guide to prevent the cables from obscuring the
front panel of the switch and the other devices installed in the rack. Use the
supplied black screw, as shown in
guide to the left or right bracket.
1-6.
"Connecting to a Power Source" section on
"Powering Considerations"
"Completing the Setup Program" section on
"Connecting to the 10/100 and
and the
to complete the installation.
"Accessing the Switch from
1-13.
Figure 3-28 and Figure 3-29
Chapter 3 Switch Installation
"Connecting
3-37.
and the "Starting the
"Connecting to an SFP
to attach the cable
78-15136-02