Installing The Optional Ac Ground Kit For Catalyst 2950 Switches - Cisco WS-C2950T-48-SI Hardware Installation Manual

Chapter 2 Installation
Figure 2-20 Mounting a Catalyst 2950 Switch to a Wall
User-supplied
screws
After the switch is mounted on the wall, power the switch as described in getting started guide.

Installing the Optional AC Ground Kit for Catalyst 2950 Switches

For switches that require a two-hole lug for grounding, you can order a kit containing the ground lug and
hardware (Cisco part number NEBS-LUG-3550=).
When you install the ground-lug kit, you cannot connect an RPS to the switch.
Note
To install the ground lug, you need these tools and equipment:
•
•
•
•
OL-6156-01
Vertical
wall stud
Face up
wall mounting configuration
Ratcheting torque screwdriver with a Phillips head that exerts up to 15 pound-force inches (lbf-in.)
or 240 ounce-force inches (ozf-in.) of pressure
Panduit crimping tool with optional controlled-cycle mechanism (model CT-700, CT-720, CT-920,
CT-920CH, CT-930, or CT-940CH)
6-gauge copper ground wire (insulated or noninsulated)
Wire-stripping tool for stripping 6-gauge wires
Vertical
wall stud
Catalyst 2950 Switch Hardware Installation Guide
Installing the Switch
2-19