Connecting To An Sfp Module - Cisco ME-C3750-24TE-M Hardware Installation Manual

Connecting to an SFP Module

Step 3
Step 4
Figure 3-40 Connecting to an Ethernet Port
Connecting to an SFP Module
Catalyst 3750 Switch Hardware Installation Guide
3-46
might not be turned on, or there might be a cable problem or a problem with the
adapter installed in the attached device. See
solutions to cabling problems.
Reconfigure and reboot the connected device if necessary.
Repeat Steps 1 through 3 to connect each device.
S Y S T
R P S
M A S T R
S T A T
D U P L X
S P E E D
S T A C K
M O D E
This section describes how to connect to SFP modules. For instructions on how
to connect to fiber-optic SFP modules, see the
Modules" section. For instructions on how to connect to 1000BASE-T SFP
modules, see the "Connecting to 1000BASE-T SFP Modules"
For instructions about how to install or remove an SFP module, see the
and Removing SFP Modules" section on page
Chapter 3 Switch Installation
Chapter 4, "Troubleshooting,"
1
2
3
4
5
6
1X
7 8
2X
"Connecting to 1000BASE-T SFP
section.
3-40.
for
9
1 0
1 1
1 2
11 X
12 X
"Installing
78-15136-02