Cisco ME-C3750-24TE-M Hardware Installation Manual page 33

Chapter 1 Using Express Setup
Follow these steps to start the Express Setup program:
Verify that no devices are connected to the switch.
Step 1
Press and hold the Mode button, as shown in
Step 2
above the Mode button turn green. This takes approximately 3 seconds.
Figure 1-4
M O D E
1 Mode button
Release the Mode button.
Step 3
Note If all of the LEDs begin to blink after you press the Mode button, release it.
Blinking LEDs mean that the switch has already been configured and cannot go
into Express Setup mode. For more information, see the
Address and Configuration" section on page
Connect the Ethernet cable (not included) to a 10/100 Ethernet port or small
Step 4
form-factor pluggable (SFP) module port on the front panel of the switch, as
shown in
78-15136-02
Starting Express Setup
S Y S T
R P S
M A S T R
S T A T
D U P L X
S P E E D
S T A C K
1
Figure 1-5.
Figure
4-2.
Catalyst 3750 Switch Hardware Installation Guide
Starting Express Setup
1-4, until the four LEDs
"Clearing the Switch IP
1-5