Cisco ME-C3750-24TE-M Hardware Installation Manual page 69

Chapter 3 Switch Installation
Follow these steps to connect the PC or terminal to the switch:
Configure the baud rate and character format of the PC or terminal to match these
Step 1
console port default characteristics:
•
•
•
•
•
After you have gained access to the switch, you can change the console baud rate
through the Administration > Console Baud Rate window in the Cluster
Management Suite (CMS).
Using the supplied RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into
Step 2
the console port, as shown in
Attach the DB-9 female DTE adapter of the RJ-45-to-DB-9 adapter cable to a PC,
Step 3
or attach an appropriate adapter to the terminal.
Start the terminal-emulation program if you are using a PC or terminal.
Step 4
78-15136-02
9600 baud
8 data bits
1 stop bit
No parity
None (flow control)
Figure 3-1.
Catalyst 3750 Switch Hardware Installation Guide
Preparing for Installation
3-9