Installing the Switch
Wall Mounting
Note
Attaching the Brackets to the Switch for Wall-Mounting
Figure 3-30 Attaching the 19-inch Brackets for Wall-Mounting
C a ta ly st
3 7 5 0
23
24
23X
25
26
27
28
24X
1
Phillips truss-head screws
Catalyst 3750 Switch Hardware Installation Guide
3-32
To install the switch on a wall, follow the instructions in these procedures:
•
Attaching the Brackets to the Switch for Wall-Mounting, page 3-32
Attaching the RPS Connector Cover, page 3-33
•
Mounting the Switch on a Wall, page 3-34
•
The illustrations in this section show the Catalyst 3750G-24TS switch as an
example. All the Catalyst 3750 switches are wall-mounted following the same
procedures.
Figure 3-30
shows how to attach a 19-inch bracket to one side of the switch.
Follow the same steps to attach the second bracket to the opposite side.
SE RI ES
Chapter 3
Switch Installation
1
78-15136-02