Chapter 3
Switch Installation
Figure 3-33 Mounting the Switch on a Wall
1
1
User-supplied screws
78-15136-02
After the switch is mounted on the wall, you might need to perform these tasks to
complete the installation, run the setup program, and access the switch:
(Optional) Connect the switches in the stacks. See the
•
StackWise Cable to StackWise Ports" section on page
Connect to the console port, and start the emulation software. See the
•
"Connecting to the Console Port" section on page 1-4
Terminal Emulation Software" section on page
Power on the switch. See the
•
page
1-6. If the switches are stacked, see the
section on page
3-13.
"Connecting to a Power Source" section on
"Powering Considerations"
Catalyst 3750 Switch Hardware Installation Guide
Installing the Switch
1
"Connecting
3-37.
and the
"Starting the
1-6.
3-35