Cisco ME-C3750-24TE-M Hardware Installation Manual page 157

Appendix D Quick Setup By Using the CLI-Based Setup Program
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
!
interface FastEthernet1/0/2
interface FastEthernet1/0/3
!
...<output abbreviated>
!
interface GigabitEthernet2/0/28
!
end
These choices are displayed:
Step 10
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots,
save it in nonvolatile RAM (NVRAM) by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
After you complete the setup program, the switch can run the default
configuration that you created. If you want to change this configuration or want
to perform other management tasks, use one of these tools:
•
•
78-15136-02
Command-line interface (CLI)
CMS from your browser
Entering the Initial Configuration Information
Catalyst 3750 Switch Hardware Installation Guide
D-13