Stacking The Switches (Optional; Stacking The Switches (Optional) - Cisco Catalyst 3750 Hardware Installation Manual

Stacking the Switches (Optional)

The auto-MDIX feature is enabled by default on switches running Cisco IOS Release 12.2(18)SE or
later. For releases between Cisco IOS Release 12.1(14)EA1 and 12.2(18)SE, the auto-MDIX feature is
disabled by default. For configuration information for this feature, see the switch software configuration
guide or the switch command reference.

Stacking the Switches (Optional)

You can stack up to nine switches by using the StackWise cables and ports to connect the switches (see
Figure
Figure D-2
Step 1 Insert one end of the StackWise cable into the StackWise port at the back of a switch. See Figure D-3.
Note
Use the window in the StackWise cable to align the connector correctly. Secure the screws tightly.
Step 2
Insert the other end of the cable into the connector of the other switch, and secure the screws tightly.
Step 3
Catalyst 3750 Switch Hardware Installation Guide
D-4
D-2). Read the "Planning the Stack" section on page 2-8
Stacking the Switches
CO NS OL
E
RAT ING
100 -200
1.6A -0>9 V ~
A, 50-6
0 HZ
CO NS OL
E
RAT ING
100 -200
1.6A -0>9 V ~
A, 50-6
0 HZ
CO NS OL
E
RAT ING
100 -200
1.6A -0>9 V ~
A, 50-6
0 HZ
Always use a Cisco-approved StackWise cable to connect the switches.
Appendix D Configuring the Switch with the CLI-Based Setup Program
DC INP
UTS FOR
POW ER REM OTE
SPE CIF SUP PLY
IED IN
MAN UAL
+12 v
@8. 5a
DC INP
UTS FOR
POW ER REM OTE
SPE CIF SUP PLY
IED IN
+12 v MAN UAL
@8. 5a
DC INP
UTS FOR
POW ER REM OTE
SPE CIF SUP PLY
IED IN
+12 v MAN UAL
@8. 5a
before you stack your switches.
OL-6336-06