G12Sxi Module - Extreme Networks Summit Summit1i Hardware Installation Manual

G12SXi Module

Figure 119 shows the G12SXi module.
Figure 119: G12SXi module
51040
Module status LEDs
1 5 9
Port status LEDs
2 6 10
3 7 11
4 8 12
=
AMBER ACTIVITY
GREEN = LINK OK
FLASHING GREEN = DISABLED
1
2
3
4
5
1000 Mbps
6
ports
7
8
9
10
11
12
The G12SXi module has 12 Gigabit Ethernet ports that use standard MT-RJ connectors, and supports
1000BASE-SX only. The default configuration of the G12SXi module is as follows. All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
• Operate in auto-negotiation mode.
LEDs
The G12SXi module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the G12SXi module, see "I/O Module LEDs" on
page 267.
Software Requirements
The G12SXi module requires that you load ExtremeWare version 6.1.4 or later on the switch.
Extreme Networks Consolidated "i" Series Hardware Installation Guide
EW_G12SXi
Configuring I/O Modules
241