Installing I/O Modules - Extreme Networks Summit Summit1i Hardware Installation Manual

BlackDiamond 6800 Series I/O Modules
Table 84: BlackDiamond ARM and MPLS module LEDs
LED Color
Status Flashing green
Flashing amber
Off
DIAG Green
Flashing amber
Amber

Installing I/O Modules

You can insert I/O modules at any time, without causing disruption of network services. Complete the
action of inserting a BlackDiamond I/O module in a reasonable time frame. Be sure to insert the
module completely to avoid partial insertion or connection of backplane connectors.
You need the following tools and equipment to install an I/O module:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• I/O module
• Appropriate type of cable for the I/O module you plan to install
To install an I/O module:
1 Select a slot for the module:
• Slots numbered 1 through 16 in the BlackDiamond 6816 chassis
• Slots numbered 1 through 8 in the BlackDiamond 6808 chassis
• Slots numbered 1 through 4 in the BlackDiamond 6804 chassis
CAUTION
You can install I/O modules only in slots 1 through 16 in the BlackDiamond 6816, slots 1 through 8
in the BlackDiamond 6808, or slots 1 through 4 on the BlackDiamond 6804. I/O modules do not fit in
slots A, B, C, or D. Forceful insertion can damage the I/O module.
2 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-left corner of the switch front panel.
3 Remove the blank faceplate from the slot to make room for the module, if applicable.
NOTE
Any unoccupied module slot in the chassis should have a blank faceplate installed to ensure
satisfactory protection from EMI and to guarantee adequate airflow through the chassis.
268
Indicates
Normal operation
Configuration error, code version error, diagnostic failure, or other
severe module error
No power
Normal operation
Diagnostics in progress
Diagnostic failure
Extreme Networks Consolidated "i" Series Hardware Installation Guide