Installing The Fan Tray - Extreme Networks BlackDiamond 10K Series Installation Manual

BlackDiamond 10808 Switch Fan Tray and Filter

Installing the Fan Tray

The BlackDiamond 10808 switch fan trays are hot-swappable. You do not need to turn off power to an
BlackDiamond 10808 switch to install a fan tray.
You need the following tools and equipment to install a fan tray:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
• Replacement fan tray
CAUTION
Only trained service personnel should perform service to BlackDiamond 10808 switch fan trays. Before
installing or removing any components, and before carrying out any maintenance procedures, see
Appendix A.
To install the fan tray in the BlackDiamond 10808 switch:
1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-right corner of the switch front panel.
2 Check the connectors for dust and packing materials.
3 To support the fan tray, place one hand under the fan tray and use the other hand to guide the fan
tray into the slot.
Gently begin to insert the new fan tray into the slot.
NOTE
If the chassis is powered on, the fan blades will begin turning as soon as the tray makes contact
with the backplane.
4 To secure the fan tray, turn the screws clockwise until they become tight.
5 Leave the ESD strap permanently connected to the chassis so that it is always available when you
need to handle ESD-sensitive components.
6 Use the command to verify successful installation.
show fan
For more information about using this command, see the ExtremeWare XOS Concepts Guide.
90 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide