Rel Lever Is In Wrong Position; Borderless Printng Not Possible - Canon imagePROGRAF iPF755 User Manual

Rel lever is in wrong position.

The Release Lever is pushed back.

Borderless printng not possible.

The print job received species a type or width of
paper that is not compatible with borderless printing.
The loaded paper is a size not compatible with
borderless printing.
Cause
Cause
Corrective Action
Pull the Release Lever forward.
Turn off the printer and wait a while before restoring
power.
Corrective Action
Follow these steps to change the settings of the print
job to enable borderless printing.
1.
Press ▲ or ▼ to select Stop Printing, and then
press the OK button.
2.
Make sure the correct printer driver for the printer
is selected and try printing again.
For information on types of paper compatible with
borderless printing, refer to the Paper Reference
Guide.
(→P.97)
Select None when you have set Detect Mismatch
on the control panel to Warning.
Press ▲ or ▼ to select Print With Border, and
then press the OK button to continue printing. The
document will be printed with a border.
Press ▲ or ▼ to select Stop Printing, and then
press the OK button.
Replace the paper with paper compatible for
borderless printing as follows.
1.
Press ▲ or ▼ to select Change Paper, and then
press the OK button.
(→P.118)
(→P.120)
2.
Replace the paper with paper compatible for
borderless printing.
(→P.105)
(→P.108)
The printer now starts printing the print job.
For information on types of paper compatible with
borderless printing, refer to the Paper Reference
Guide.
(→P.97)
Press ▲ or ▼ to select Print With Border, and
then press the OK button to continue printing. The
document will be printed with a border.
Messages regarding paper
Error Message 763