Problems With The Printing Quality; Printing Is Faint - Canon imagePROGRAF iPF755 User Manual

Problems with the printing quality

Printing is faint

You may be printing on the wrong side of the paper.
The Printhead nozzles are clogged.
Because the printer was left without ink tanks
installed for some time, ink has become clogged in
the ink supply system.
Paper is jammed inside the Top Cover.
The ink was not dry when paper was cut.
Printing may be faint if Print Quality in Advanced
Settings in the printer driver is set to Standard or
Draft.
Cause
Problems with the printing quality
Corrective Action
Print on the printing surface.
Print a test pattern to check the nozzles and see if
they are clogged.
(→P.692)
After the ink tanks have been installed for 24 hours,
run Head Cleaning B from the Control Panel.
(→P.694)
Follow the steps below to remove the jammed piece
of paper inside the Top Cover.
1.
Open the Top Cover and make sure the Carriage
is not over the Platen.
2.
Remove any scraps of paper inside the Top Cover.
(→P.122)
(→P.147)
3.
Close the Top Cover.
Specify a longer drying period in the Control Panel
menu, in Paper Details > Roll DryingTime.
(→P.49)
In Advanced Settings of the printer driver, choose
Highest or High in Print Quality.
Printing in Draft or Standard mode is faster and
consumes less ink than in Highest or High modes,
but the printing quality is lower.
(→P.189)
Troubleshooting 731