Shutting Down The Projector - BenQ SH910 User Manual

• Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
• Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD
menus. Use
• Reminder Messge in the SYSTEM SETUP: Basic >Menu Settings menu sets whether to
display reminder messages on screen. Use

Shutting down the projector

1. Press
displays prompting you. If you don't respond
in a few seconds, the message will disappear.If
you use the remote control, press OFF to shut
down the projector.
2. Press
indicator light flashes red, the projection lamp
shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the
projector.
• To protect the lamp, the projector will not respond
to any commands during the cooling process.
3. Once the cooling process finishes, the POWER indicator light is a steady red and fans
stop.
4. Disconnect the power cord from the power putlet if the projector will not be used in
an extended period of time.
• If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns red.
• Actual lamp life may vary due to different environmental conditions and usage.
38 Operation
/ to select your language.
I
Power and a confirmation message
I
I Power a second time. The POWER
I
/ to select a suitable time frame.
/ to select a preferred position.
/ to select your desired setting.