BenQ SH910 User Manual page 65

FUNCTION)
Picture Mode
Reference
Mode
Brightness
Contrast
Color
Tint
Sharpness
DESCRIPTION
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
picture mode" on page 31
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See
details.
This function is only available when User 1 or User 2 is selected.
Adjusts the brightness of the image. See
page 32 for details.
This function is only available when User 1 or User 2 is selected.
Adjusts the degree of difference between dark and light in the image.
See"Adjusting Contrast" on page 32
This function is only available when User 1 or User 2 is selected.
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 32
This function is only available when User 1 or User 2 is selected.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC or PAL.
Adjusts the red and green color tones of the image. See
Tint" on page 32 for details.
This function is only available when User 1 or User 2 is selected.
This function is only available when a Video or S-Video signal is
selected and the system format is NTSC or PAL.
Adjusts the image to make it look sharper or softer. See
Sharpness" on page 32
This function is only available when User 1 or User 2 is selected.
for details.
"Setting the User 1/User 2 mode" on page 31
"Adjusting Brightness" on
for details.
for details.
"Selecting a
for
for details.
"Adjusting
"Adjusting
Operation 65