Timing Of Replacing The Lamp - BenQ SH910 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace
the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
Go to http://lamp.benq.com
The Lamp indicator light will light up if the lamp becomes too hot. See
for details.
The following lamp warning displays will remind you to change the lamp.
The warning messages below are for reference only. Please follow the actual on-screen
instructions to prepare and replace the lamp.
Status
Install a new lamp for optimal performance. If the
projector is normally run with Economic selected
("Setting Lamp Mode as Economic" on page
you may continue to operate the projector until
the next lamp warning appears.
Press MODE/ENTER to dismiss the message.
A new lamp should be fitted to avoid the
inconvenience when the projector runs out of
lamp time.
Press MODE/ENTER to dismiss the message.
It is strongly recommended that you replace the
lamp at this stage. The lamp is a consumable item.
The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level has
significantly diminished.
Press MODE/ENTER to dismiss the message.
The lamp MUST be replaced before the projector
will operate normally.
Press MODE/ENTER to dismiss the message.
"XXXX" shown in the above messages are numbers that vary depending on different models.
for a replacement lamp.
74),
"Indicators" on page 79
Message
Maintenance 75