Controlling The Projector Through A Lan Environment - BenQ SH910 User Manual

Controlling the projector through a LAN
environment
Network Settings allow you to manage the projector from a computer using a web browser
when the computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the LAN input jack of the projector and the
other end to the RJ45 port.
2. Press MENU/EXIT and then press
is highlighted.
3. Press
Settings page displays.
4. Press
5. Press
6. Press
7. Re-enter the Wired LAN page. The IP Address, Subnet Mask, Default Gateway, and
DNS Server settings will be displayed. Note down the IP address.
If the IP Address still does not display, contact your ITS administrator.
If you are in a non-DHCP environment:
1. Repeat steps 1-4 above.
2. Press
3. Contact your ITS administrator for information on the IP Address, Subnet Mask,
Default Gateway, and DNS Server settings.
4. Press
5. Press
Configuring the Wireless LAN Settings
BenQ wireless dongle
Internet
to highlight Network Settings and press MODE/ENTER. The Network
to highlight Wired LAN and press MODE/ENTER.
to highlight DHCP and press
to highlight Apply and press MODE/ENTER.
to highlight DHCP and press
to select the item you want to modify and enter the value.
to highlight Apply and press MODE/ENTER.
IP Router
/ until the SYSTEM SETUP: Advanced menu
/ to select On.
/ to select Off.
Operation 39