Switching Input Signal - BenQ SH910 User Manual

ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You can
press MENU/EXIT to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time. When starting up, the projector automatically searches for
the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is the default of
this projector) if you want the projector to automatically search for the signals.
You can also manually cycle through the available
input signals.
1. Press SOURCE on the projector. A source
selection bar displays.
2. Press
selected and press MODE/ENTER.
Once detected, the selected source information will
display on the screen for seconds. If there is multiple
equipment connected to the projector, repeat steps 1-2
to search for another signal.
• The brightness level of the projected image will change
accordingly when you switch between different input
signals. Data (graphic) "PC" presentations using mostly
static images are generally brighter than "Video" using
mostly moving images (movies).
• The input signal type effects the options available for the
Picture Mode. See
• The native display resolution of this projector is in a 16:9 aspect ratio. For best display
picture results, you should select and use an input signal which outputs at this resolution.
Any other resolutions will be scaled by the projector depending upon the 'aspect ratio'
setting, which may cause some image distortion or loss of picture clarity. See
the aspect ratio" on page 29
Changing Color Space
In the unlikely event that you connect the projector to a DVD player via the projector's
HDMI input and the projected picture displays wrong colors, please change the color space
to YUV.
1. Press MENU/EXIT and then press
2. Press
color space.
This function is only available when the HDMI input port is in use.
28 Operation
/ until your desired signal is
"Selecting a picture mode" on page 31
for details.
to highlight Color Space Conversion and press
for details.
/ until the SOURCE menu is highlighted.
"Selecting
/ to select a suitable