Table of Contents
Advertisement
Changing the password
1. Go to Advanced Menu - Settings > Security Settings > Change Password.
2. Press OK. The message — Input Current Password" appears.
3. E nter the old password.
• If the password is correct, another message — Input New Password" appears.
• If the password is incorrect, the password error message will appear, and the message — Input
Current Password" appears for your retry. Y ou can press BACK to cancel the change or try
another password.
4. E nter a new password.
5. Confirm the new password by re-entering the new password.
Disabling the password function
To disable password protection, go to Advanced Menu - Settings > Security Settings > Power
On Lock and press / to select Off. The message — Input Current Password" appears. E nter the
current password.
• If the password is correct, the OSD menu returns to the Security Settings page. Y ou will not
have to enter the password next time turning on the projector.
• If the password is incorrect, the password error message will appear, and the message — Input
Current Password" appears for your retry. Y ou can press BACK to cancel the change or try
another password.
Though the password function is disabled, you need to keep the old password in hand should you ever need to
re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time.
However, it can only display one full screen at a time. When starting
up, the projector automatically searches for the available signals.
B e sure the Advanced Menu - Settings > Auto Source Search
menu is On if you want the projector to automatically search for the
signals.
To select the source:
1. Press SOURCE. A source selection bar appears.
2. Press
/
until your desired signal is selected and press OK.
Once detected, the selected source information will appear at the corner of the screen for seconds.
If there is multiple equipment connected to the projector, repeat steps 1-2 to search for another
signal.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector' s native
resolution. Any other resolutions will be scaled by the projector depending upon the — aspect ratio" setting,
which may cause some image distortion or loss of picture clarity. S ee
24
Operation
Aspect Ratio on page
27.
Advertisement
Table of Contents
