Belkin F1PG111EN User Manual page 9

Knowing Your Belkin Message Manager
(a)
(b)
(c)
(a) FXO (POTS) Phone
This port is for connection to your existing Phone Line. Use an RJ-11
cable to connect to and exiting PSTN analog telephone service. It is
recommended you connect this port to provide 911 emergency support
and in the rare case that your Broadband service or electricity go down.
(b) FXS (TEL) Phone Line
This port is for connection to your telephone Handset. Use the RJ-11
cable that was provided with the Message Manager to connect the
telephone to this port.
(c) Reset Switch
The "Reset" button is used in rare cases when the Message Manager
may function improperly. Resetting the Message Manager will restore the
Message Manager's normal operation while maintaining the programmed
settings. You can also restore the factory default settings by using the
Reset button. Use the restore option in instances where you may have
forgotten your custom password.
1. Resetting the Belkin Message Manager
Push and release the Reset button. The lights on the Belkin Message
Manager will momentarily flash while the unit reboots.
2. Restoring the Factory Defaults
Press and hold the Reset button for at least five seconds then
release it. The lights on the Message Manager will momentarily flash
while the unit reboots.
(d) LAN port
Connect your wired (non-wireless) computers to this port or use it to
connect a wireless Access Point. This port is RJ45, 10/100
auto-negotiation, auto-uplinking ports for standard UTP category 5 or
6 Ethernet cable. This port corresponds to the LAN LED on the front
of the Message Manager.
(e) WAN port
This port is for connection to your cable or DSL modem. Use the
cable that was provided with the Message Manager to connect the
modem to this port. Or you may use it to connect to your existing
router setup. Use of a cable other than the cable supplied may not
work properly.
(f) Power Jack
Connect the included 12V DC, 1A power supply to this jack.
(d) (e)
7 7
(f)
1
2
3
4
5
6
7
8
9
10
11
12