Table of Contents
Advertisement
Connecting and Configuring Your Message Manager
Connecting and Configuring Your Message Manager
Connecting your Message Manager to a Router/Gateway
Option 2 - Installing the Belkin Message Manger as the Primary
router in your Network (recommended).
cable/DSL modem is currently connected directly to your computer)
Easy Install Wizard
Belkin has provided the Easy Install Wizard software to make installing
your Message Manager a simple and easy task. You can use it to get
your Message Manager up and running in minutes. The Easy Install
Wizard requires that your Windows 98 SE, Me, 2000, or XP computer
be connected directly to your cable or DSL modem and that the
Internet connection is active and working at the time of installation.
If it is not, you must use the "Alternate Setup Method" section of this
manual to configure your Message Manager. Additionally, if you are
using an operating system other than Windows 98 SE, Me, 2000, or
XP, you must set up the Message Manager using the "Alternate Setup
Method" section of this manual.
Step 1
Run the Easy Install Wizard Software
1.
Shut down any programs that are running on your computer at this time.
2.
Make sure you have the following items at the computer that is
now directly connected to the cable or DSL modem. DO NOT
CONNECT THE MESSAGE MANAGER AT THIS TIME.
• The Message Manager
• The Easy Install Wizard CD-ROM
• The power supply
• RJ45 Ethernet networking cable
• This User Manual
3.
Turn off any firewall or Internet connection sharing software on
your computer.
4.
Insert the Easy Install Wizard software CD into your CD–ROM
drive. The Easy Installation Wizard screen will automatically
appear on your screen within 15 seconds. If it does not, select
your CD-ROM drive from "My Computer" and double-click on the
file named "Setup.exe" on the CD-ROM.
(Select this method if your
12
12
Advertisement
Table of Contents
