Tone Control Setting; Adjusting The Sound Quality; Tone Defeat Mode; Channel Level - Denon AVR-1906 Operating Instructions Manual

Basic Operation
2 Surround parameters r
ROOM SIZE:
This sets the size of the sound field.
There are five settings: "small", "med.s" (medium-small),
"medium", "med.l" (medium-large) and "large". "small"
recreates a small sound field, "large" a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level
if the sound seems distorted.
DELAY TIME:
The delay time can be set within the range of 0 to 110 ms only
in the matrix mode.
TONE CONTROL:
This can be set individually for each surround mode except
DIRECT.

Tone control setting

2 Adjusting the sound quality (tone)
The tone control function will not work in the DIRECT mode.
1
TONE CONTROL
Press the button.
The tone switches as follows each time the TONE CONTROL
button is pressed.
BASS TREBLE
2
SELECT
Turn the knob to adjust the level of the
bass or treble.
To increase the bass or treble:
Turn the control clockwise. (The bass or treble sound can be
increased up to +12 dB in steps of 2 dB.)
To decrease the bass or treble:
Turn the control counterclockwise. (The bass or treble sound
can be decreased down to –12 dB in steps of 2 dB.)

2 Tone defeat mode

If you do not want the bass and treble to be adjusted, turn on the
tone defeat mode.
TONE DEFEAT
Press the button.
The signals do not pass through the bass and treble
adjustment circuits, thus resulting in higher quality sound.
26
ENGLISH

Channel Level

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1
CH SELECT
Press the button to select the
speaker whose level you want to adjust.
The channel switches as shown below each time the button
is pressed.
FL C FR SR
SW SL SBL SBR
When the surround back speaker setting is set to "1sp" for
"Speaker Configuration", this is set to "SB".
"SB" appears only when the "Power Amp Assign." setting
is the surround back mode.
2
CURSOR F F G G
Press the or button to adjust the
level of the selected speaker.
The default setting of the channel level is 0 dB.
The level of the selected speaker can be adjusted within the
range of +12 to –12 dB by pressing the CURSOR buttons.
The SW channel level can be turned off by decreasing it one
step from –12 dB.
OFF ´ –12 dB ´ +12 dB
ENGLISH
Basic Operation