Auto Setup; Connecting A Microphone; Before Performing The Auto Setup Procedure; Switching The Front Speaker - Denon AVR-1707 Operating Instructions Manual

Easy Setup Procedure
<ON/STANDBY>
<POWER> <SPEAKER> <SETUP MIC> D H F G
[MODE SELECTOR 1]
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit

Auto Setup

The AVR-1707's auto setup use the attached microphone to measure
the acoustic properties in the room and automatically make the
optimum settings.
• To make the sound field settings manually (
q Connecting a microphone
1
Connect the attached setup microphone to
MIC >
.
[ON/SOURCE]
Sound receptor
2
Mount the setup microphone on a camera tripod, etc.,
D H F G
and set with the receptor pointing towards the ceiling.
D H F G
Place the setup microphone's sound receptor at the height of the
ears in the listening position.
It is not possible to measure properly if there are any obstacles
between the speakers and microphone. Check that there are no
obstacles.
page 45).
< SETUP
Microphone
10
ENGLISH
w Before performing the Auto Setup procedure
1
Turn on your subwoofer.
Set the volume to halfway and set the crossover frequency to
the maximum or Low pass filter off if your subwoofer can adjust
the output volume and the crossover frequency.
Some subwoofers have a standby mode. Be sure to turn this
function off before performing the Auto Setup procedure.
2
Turn on your monitor.
< POWER >
3
Press .
ON:
¢
The power indicator lights red.
£ OFF:
The power turns off and the indicator is off.
4
< ON/STANDBY >
[ON/SOURCE]
Press or
• The power indicator blinks green and the power turns on.
5
[MODE SELECTOR 1]
Set to "AUDIO".
• Auto Setup mode is not displayed when using headphones.
e Switching the front speaker
< SPEAKER >
Press to select the front speaker (Front A,
Front B or Front A+B).
ENGLISH
Easy Setup Procedure
.