Omron NS - SETUP Setup Manual page 64

3-2 Starting the PT
↓
PT starts operating
The PT goes into RUN mode and starts operating according to the screen data in the PT.
When the PT is connected using communications conditions other than the set conditions, a
message "Connecting..." will be displayed at the bottom right of the screen, and the PT will
be in standby status until normal connection is established.
To change the communications settings, display the System Menu and change the settings.
Precautions
for Safe Use
Reference
3-10
Confirm the safety of the system before turning the power ON and OFF or
pressing the reset switch.
If tags are used in the screen data in the NS-series PT, tags will be verified before opera-
tion is started. Refer to 6-11 Verifying Tags for details.