Omron NS - SETUP Setup Manual page 47

NS8 Rear Panel
Power Input Terminal Block Cover
Covers the power input terminal
Main Circuit DC
block.
Input Terminals
Used to connect
the power supply.
FG Terminal
Used to prevent
malfunctions due to
noise interference.
USB Host Connector
Used to connect to printers.
It is a USB Type A connector.
Refer to 3-5-1 Connecting to
a Printer Compatible with
ESC/P Raster or BJ Raster.
Confirm system safety before turning the power ON/OFF or restarting. Other-
Precautions
for Safe Use wise the system may operate unpredictably.
Expansion Interface Connector
Used to mount the Video Input
Unit or the Controller Link
Interface Unit.
Serial Port B Connector
Used to connect the host, CX-
Designer, and Bar Code Reader.
Uses an RS-232C 9-pin
connector.
USB Slave Connector
This is a USB Type B connector.
Refer to 3-3-2 Connecting via USB. It is used to connect to CX-Designer.
A PictBridge-compatible printer can also be connected to the NS8-V2.
(Refer to 3-5-2 Connecting a PictBridge-compatible Printer.)
2-2 Part Names and Functions
Memory Card Connector
Used to connect the
memory card for storing
and transmitting screen
data, log data, and system
programs.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Reset Switch
Used to initialize the PT.
The status of screen data,
other registered data, and
the system menu, however,
will not change.
Battery Cover
The battery is installed
underneath the cover.
Serial Port A Connector
Used to connect the host, CX-Designer, and
Bar Code Reader. Uses an RS-232C 9-pin
connector.
Ethernet Connector
Used to connect the Ethernet cable. Uses a
10Base-T/100Base-T 8-pin modular plug.
2-13