Procedure For Running Ns-Series Pts - Omron NS - SETUP Setup Manual

1-4 Procedure for Running NS-series PTs

1-4 Procedure for Running NS-series PTs

Use the following procedure to start up the NS-series system.
Refer to following pages.
1:1 NT Link: 4-2 and A-8
1:N NT Link: 4-7 and A-9
High-speed 1:N NT Link:
4-15 and A-9
Ethernet: Section 5
EtherNet/IP: Section 5
Controller Link: Section 5
Host Link:
Refer to the Host Connection
Manual (Host Links).
Temperature Controllers:
Refer to the Host
Connection Manual
(Temp. Control, MemLink).
Memory Links:
Refer to the Host
Connection Manual:
(Temp. Control, MemLink).
Other Devices:
Refer to the Host
Connection Manual
(Multivendor Connection).
PT connections
Connecting to Other Devices
Note 1. RUN mode is entered automatically if screen data already exists.
2. The system program is installed in special situations only, such as when the system program
3. The system menu can be operated as required to initialize data saved in the PT.
4. For the NS15, the System Menu can be displayed by pressing one of the four corners of the
5. When errors occur during operation, check I/O and setting statuses as required.
1-10
Host
Host settings
Programming
Operation
System maintenance See note 5.
An error message is displayed if screen data does not exist. Transfer screen data from either
the CX-Designer or a Memory Card.
is being changed or recovered.
touch panel twice in a row. For the NS5, NS8, NS10, and NS12, the system menu can be dis-
played by simultaneously pressing two of the four corners of the touch panel.
PT
Panel installation
Refer to Page 3-4.
Peripheral connections
Power connections
Refer to Page 3-6.
See
Power ON
note
1.
See
System program
note
installation
2.
See
note
Data initialization
3.
Refer to 6-2-1 Screen
Data Area Format.
Screen transfer
Refer to 3-6-3 Transferring Data with Memory Cards.
See note 4.
System menu settings
Refer to Section 6-1 Operating
Modes and System Menu.
Host connections
RS-232C: Section 4
Ethernet: Section 5
Controller Link: Section 5
EtherNet/IP: Section 5
Settings/com check
CX-Designer
Installation on the
computer
Refer to the CX-Designer
User's Manual.
Screen creation
Refer to NS-series PT
Programming Manual
and the CX-Designer
User's Manual.