Changing Scenes; Copying And Clearing Scenes - Omron F400 - 06-1999 Operation Manual

Starting and Quitting
2. Select SET to display a list of scene processing options. The options will not be
3. Select either Color filter or Color pickup and press the ENT Key. The settings
Settings screen for Color Filter Mode
Settings
Adjust
Position compensation
Measurement region
Expression
Color bar displayed.
Note Changing between Color Filter and Color Pickup Modes
To change the scene mode for selected scenes, clear the scene and then change the
scene mode.
2-2-3

Changing Scenes

All the settings for measurement conditions are input for a specific scene. Up to 16
scenes can be set, numbered from 0 to 15. Scenes can be changed to switch between
different measurement conditions for different measurement setups or measurement
objects. Scene 0 will be displayed by default when the power is turned ON. Setup can
be changed by simply changing scenes. Refer to Scene in the Glossary on page 145.
16
displayed if measurement conditions are already set for the selected scene num-
ber. The scene number must be changed or the settings cleared before the
options can be changed.
Scn 0BMONB
SET
MON
RUN
SYS
SAVE
screen for the selected scene mode will be displayed.
Color filter
Color pickup
Color thr
Copying and Clearing Scenes on p. 17
1 2
----
Color thr
3
Settings screen for Color Pickup
Mode
Settings
Adjust
Position compensation
Measurement region
Expression
No color bar displayed.
Section
--ms
Color thr
— Filter/Pickup —
2-2