Display Settings; Measurement Screen Settings - Omron F400 - 06-1999 Operation Manual

Display Settings

6. Select Receive and input the file name.
Loading Data from the Personal Computer
1. Follow steps 1 to 3 in the above procedure to connect the F400 and the personal
2. Select Transfer/Send File from the Hyper Terminal menu. Select the file to be
3. Select Send.
4. Perform load operations at the F400.
5-4 Display Settings
5-4-1

Measurement Screen Settings

The following explains the settings procedures for the background color for charac-
ters displayed on the screen and menu boxes, conditions for storing images to
memory, and displayed contents for measurement results.
Image Types to be Stored and Measurement Result Display
The F400 can store up to 16 measured images. It is possible to set the F400 to only
store images which resulted in NG judgements, or to store all images regardless of
the measurement result. Also, measurement results and other information can be
displayed on the measurement screens and monitor screens. Make settings to deter-
mine which information will be displayed.
Note Stored images are cleared when the power is turned OFF. Save the images by back-
ing them up to a personal computer.
100
The data will be transferred from the F400 to the personal computer.
During communications, the F400 will generate a timeout error if there is no
response from the external device for more than 30 s. An error message will be
displayed on the screen, and the error terminal on the terminal block will turn ON.
computer.
sent and set the protocol to Xmodem .
The Data Transfer Window will be displayed.
The data will be transferred from the personal computer to the F400.
During communications, the F400 will generate a timeout error if there is no
response from the external device for more than 30 s. An error message will be
displayed on the screen, and the error terminal on the terminal block will turn ON.
Data will be loaded.
Image data 0
Execute Cancel
4
Section 5-4
— Filter/Pickup —