Startup Mode; Key Allocation - Omron F400 - 06-1999 Operation Manual

Startup Mode

1. Go to SYS/Set key operation and press the ENT Key. The Setting Screen will be
2. Move the cursor to the item to be changed and press the ENT Key. A selection list
3. When the required settings have been made, move the cursor to End and press
5-6 Startup Mode
Use the following procedure to set the startup scene and mode that will be used when
the power is turned ON.
If the F400 is set to start in Run Mode for the scene where the desired measurement
conditions are registered, measurement of objects can be started immediately by
simply turning the power ON and pressing the TRIG Key.
When this setting is set to OFF , the F400 will start up in the most recently saved status.
The default setting is for scene 0 and MON (Monitor) mode.
1. Move the cursor to SYS/Startup mode , and press the ENT Key.
The default key allocations are as shown below:
ESC :
SFT+ENT :
SFT+ESC :
SFT+ : Change backgroundB
SFT+ : Change backgroundB
SFT+ :
SFT+ :
displayed.
White balance
Communications settings
Output
Backup
Display settings
Set key operation
Startup mode
Error method
Version
will be displayed.
ESC :
SFT+ENT : Judge conditionsB
SFT+ESC : Display settingsB
SFT+ : Change backgroundB
SFT+ : Change backgroundB
SFT+ :
SFT+ :
End
the ENT Key. The set conditions will be saved.
The Setting Window will be displayed.
White balance
Communications settings
Output
Backup
Display settings
Set key operation
Startup mode
Error method
Version
NoneB
Judge conditionsB
Display settingsB
Previous imageB
Next imageB
End
1
2
NoneB
Previous imageB
Next imageB
3
1
Section 5-6
— Filter/Pickup —
107