Adjustment Tips For The Operating Menu; Switching Between Channel Banks; Switching Between The Channels In A Channel Bank; Selecting The Frequencies To Be Stored In The Channel Bank "U - Sennheiser ew 300 IEM G2 Instructions For Use Manual

BANK
Bank
CHAN
Channel
TUNE
Tune
SCAN
28

Adjustment tips for the operating menu

Switching between channel banks

Via the "Bank" menu, you can switch between the nine channel banks of the
ew 300 IEM G2 transmitter and receiver. The channel banks "1" to "8" have
up to 12 switchable channels that are factory-preset to a transmission/
receiving frequency (see "The channel bank system" on page 5). The channel
bank "U" (user bank) also has up to 12 switchable channels to store your
selection out of 1,440 transmission/receiving frequencies that are freely
selectable within the preset frequency range.
When switching from one channel bank to another, the channel with the
lowest channel number is automatically displayed. If, during the last scan of
this channel bank, an interfering frequency was detected on the channel with
the lowest channel number, the receiver display panel automatically displays
the next free channel (see below).

Switching between the channels in a channel bank

Via the "Channel" menu, you can switch between the channels in a channel
bank.
Always set the transmitter and the receiver of a transmission link to the same
channel. After scanning a channel bank (see "Scanning the channel banks for
free channels (receiver only)" on page 28), only the free channels are
displayed. Set the transmitter to one of the free channels.
Selecting the frequencies to be stored
in the channel bank "U"
Via the "Tune" menu, you can select the frequencies to be stored in the
channel bank "U" (user bank).
When you have selected one of the channel banks "1" to "8" and then select
the "Tune" menu, the transmitter or receiver automatically switches to
channel 01 of the channel bank "U". In this case, "U.01" briefly appears on
the display.
Use the / rocker button to select the desired transmission or receiving
frequency. Transmission and receiving frequencies are tunable in 25-kHz
steps within a switching bandwidth of 36 MHz max. For intermodulation-
free frequencies, please refer to the enclosed frequency table.
Scanning the channel banks for free channels
(receiver only)
Before putting one or several transmission links into operation, you should
scan the selected channel bank for free channels.
Starting the scan and storing the scan result
Before starting the scan, switch all transmitters of your system off, since
channels used by switched-on transmitters will not be displayed as "free
channels".
Select the "SCAN" menu.