Fan - HP 250R G9 Maintenance And Service Manual

4. Remove the fingerprint reader (4) from the computer.
To install the fingerprint reader, reverse this procedure.

Fan

To remove the fan, use this procedure and illustration.
Table 5-12 Fan description and part number
Description
Fan
Before removing the fan, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the fan:
1. Remove the USB board cable (1) from the top of the fan.
2. Disconnect the fan cable (2) from the system board.
3. Disconnect the power connector (DC-in) cable (3) from the system board and remove the cable
from the clips in the fan.
4. Remove the Phillips M2.0 × 4.0 screw (4) that secures the fan to the computer.
Preparation for disassembly on page
Bottom cover on page
Battery on page 32).
31).
Spare part number
L52034-001
31).
Fan 45