Actual Value Channel (Drive To Master) - Siemens SIMOVERT FC Series Operating Instructions Manual

Master Drives
CBD
01/23/98
5.2.2

Actual value channel (drive to master)

...Section, Start-up / parameterization "Expert application" of the drive Instruction Manual
Change process
data wiring ?
no
Connect receive
channel:
- control words
- setpoints
Connect response
channel:
- status words
- actual values
Other CBD relevant
Continue in Section, Start-up / parameterization "Expert application" of the drive Instruction Manual.
Fig. 5.5 Process data combination, actual value channel for CU2. Other drives are similar with different parameter numbers.
The actual value process data (PZDi, i = 1..16) are assigned to the appropriate status words and actual values using
the indexed parameter "CB/TB actual values" (also refer to Fig. 4.4).
"CB/TB actual values"
Each index stands for a process data (e. g. 5 → PZD5 etc.). Please enter the number of the parameter, whose value
you wish to transfer using the appropriate process data, into parameter "CB/TB actual values" (also refer to the
converter Instruction Manual, Section 5 "Parameter list") under the particular index.
The status word should always be entered in PZD1 word (Fig. 4.4) of the PZD response (actual value channel), and
the main actual value in the PZD2 word. The further assignment of PZD (PZD1 up to, if required, PZD16), is not
defined. If the main actual value is transferred as 32-bit value, then it occupies PZD2 and PZD3.
The significance of the status word bit is described in the converter Instruction Manual, Section "Start-up aids".
44
5 Start-up
5.2 Process data combination
5.2.2 Actual value channel (drive to master)
yes
Refer to Section 4.3.1
Refer to Section 4.3.2
parameters
Refer to Section 4.3.3
CUVC & CUMC
P734.01 to P734.16
DC-Master
U734.01 to U734.16
SIMOVERT MASTER DRIVES
CU2
P694.01 to P694.16
Siemens AG 477 759 4070 76 J AA-74
Betriebsanleitung / Operating Instructions