Mounting Positions Of The Cbl In Compact And Chassis Units Of Masterdrives Vectorcontrol (Cuvc) And Masterdrives (Cumc) - Siemens SIMOVERT FC Series Operating Instructions Manual

Masterdrives cbc - communication board can-bus

Table of Contents

Mounting positions of the CBL in Compact and chassis units of

MASTERDRIVES VectorControl (CUVC) and MASTERDRIVES

Position of the slots

In the electronics box of the compact-type and chassis-type converters

and inverters, there are up to six slots available for installing an optional

board. The slots are marked with the letters A to G. Slot B is not

present in these types of unit; it is used in Compact PLUS units.

If you wish to use Slots D to G, you must first mount the LBA (Local

Bus Adapter) and the corresponding adapter board.

In principle, you can operate the optional CBL board (Communication

Board CC-Link) in any slot. Please bear in mind, however, that an

encoder board always needs Slot C and that the LBA requires the slots

to be used in a particular sequence.

The CBL can be mounted on the adapter board in both slots, i.e. TOP

and/or BOTTOM.

The slots are located in the following positions:

Adapter board in mounting pos. 2

Adapter board in mounting pos. 2

Adapter board in mounting pos. 3

Adapter board in mounting pos. 3

Adapter board with optional boards and position of the slots for compact

and chassis units

Electronics box

Optional boards

6SE7087-6NX84-0GB0

Operating Instructions

SIMOVERT MASTERDRIVES

Chapters

Table of Contents